Processor Module And System Board Dust Covers - HP Visualize J5000 - Workstation Service Handbook

1. To remove the protective dust
cover on the processor module,
grasp and pull the cover evenly
A
2. To remove the protective dust cov-
B
er on the system board, grasp the tab
at the end of the cover and gently
rock the cover back and forth while
gently pulling it up
Figure 5–21. Processor Module and System Board Dust Covers
Figure 5–22. J282 Processor Modules
5–26 Field Replaceable Units
3. To install processor module, insert
the module into the guides and press
firmly and evenly into place to ensure
the module is properly seated.
NOTE: Replace the protective dust cover
on the processor module being returned