Kyocera KM-C2520 Operation Manual page 97

Message
Call for Service
Time for maintenance
Time for scheduled
maintenance
Communication Error
No DC Loop
No Dial Tone
No Response
No encryption code is
registered.
Procedure
Maintenance by qualified service personnel is required.
Contact your service representative, an authorized
service center or the place of purchase. If [C] and a
4-digit number are displayed as well, inform the service
personnel of the displayed number.
Maintenance by qualified service personnel is required.
Contact your service representative, an authorized
service center or the place of purchase.
An error has occurred during a fax transmission or fax
reception. Check the error code – that indicates the
origin of the error – on the corresponding Transmission
Report (or Reception Report) that is printed out in order
to confirm the cause of the error.
The modular cord may not be connected properly to
either the telephone or the line jack (L) on the fax. Either
that, or there is a problem with the telephone line. In this
case, contact your telephone company.
Dialing was accomplished, but connection to the other
party was not possible. Check with the other party.
The destination was dialed using a one-touch key that
was designated for Encrypted Transmission, but the
Encrypted Transmission was not possible because the
corresponding Encryption Key is no longer registered in
your fax.
Troubleshooting
Page
______
______
10-11
______
______
5-59
5-66
4-5