Kyocera KM-C2520 Operation Manual page 44

Fax Operation (Basic Use)
> Checking the status of the transmission...
Press the [Status] ([Act status]) key in
the bottom right of the touch panel. The
document number and information
related to the other party will be
displayed.
> Stopping the transmission in progress
It is possible to cancel the ongoing
operation by pressing the [Stop] key in
the confirmation screen that was
accessed above. Press the [Close] key
to return to the previous screen.
If the Documents Were Set on the Platen...
Whenever you set the documents that you want to transmit on the platen, close the Document
Processor in order to allow the machine to detect the size of those documents. If you are
transmitting information from books or other types of documents that will not allow you to close the
Document Processor, it is necessary to indicate the document size manually. (Refer to page 2-6.)
NOTE: In addition, any time you set documents on the platen for transmission, a menu like that
shown below will appear in the message display once you press the Start key and the documents
have been scanned. In this case, perform the following procedure.
> If you have more documents to send...
1
NOTE: The next document(s) may also be set in the Document Processor.
2
2-8
Set the next page to be scanned on the platen.
Press the [Yes] key.
for fax transmission.
riginal & assign destination.
TX
Abbrev.
setting
Application
Register
Check Status of Fax
Status of Fax
Port
Doc #: 020.
Dialing.
03.
Stop
Storing data into memory
Continue scanning?
Yes
Memory usage:
OCT-11-2005 16:00
Dest.
check
Re-dial
On-hook
Memory TX
Auto RX
Print Report
Status
Print
No
.0%
Memory
OCT-11
Memory
OCT-11