HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 84

Specifies the outgoing email server (SMTP) for use of the
Email (SMTP)
scanning to email feature in the embedded web server. This mail
Server (for
server will be used when any user scans to email from the MFP (or
outgoing
All-in-One device) attached to the print server. See also
mail)
Server
Specifies the number of seconds that an idle connection for
scanning (either
Scan Idle
software) is allowed to remain open. If set to 0, the timeout is
Timeout
disabled and the connection will remain open until closed by the
device at the other end.
Security
Admin Password
Access Control
Admin Password setting
Networking
Click on the
Security
page, beneath
the desired value and click
For controlled access to configuration and status information through the embedded
web server and Telnet, use this page to set or clear an administrative password. If a
password is set, you will be prompted for this password to access these print server
web pages.
Access Control (host access list)
Networking
Click on the
Security
page, beneath
This page allows you to create a host access list on the print server. A host access list
specifies individual host systems, or networks of host systems, that will be allowed to
access the print server and the attached network printing device. Up to 10 entries can
be included on the host access list. If the list is empty (no hosts are listed), any
supported system can access the print server.
Note: Use caution with this feature. You may lose your ability to
communicate with the print server if your system is improperly
specified in the list.
Host systems are specified by their IP addresses or network number. If the network
contains subnets, a "mask" may be used to identify whether the IP address designates
an individual host system or a group of host systems.
To clear all entries in the host access list, enable the
[Apply]
click . To add an entry into the host access list, use the
fields to specify a host, then click
above.
web scanning
(host access list)
tab at the top of the web page. In the left column of the
Admin Password
, select
[Apply]
.
tab at the top of the web page. In the left column of the
Access Control
, select
[Apply]
.
or the client's full-function scanning
. To assign a parameter setting, enter
.
Clear Allow Table
IP address
DNS
checkbox and
Mask
and