HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 39

Enables or disables the Service Location Protocol (SLP) operation on the print server. SLP is
used by selected HP software applications to automate device discovery.
slp-config:
Specifies the IP multicast Time To Live (TTL) setting for Service Location Protocol (SLP)
packets. The default value is 4 hops (the number of routers from the local network). The
ttl-slp:
range is 1–15. When set to -1, multicast capability is disabled.
The number of seconds that an idle print data connection is allowed to remain open. Since
the card supports only a single TCP connection, the idle timeout balances the opportunity of
idle-timeout: a host to recover or complete a print job against the ability of other hosts to access the
printer. The acceptable values range from 0 to 3600 (1 hour). If set to 0, the timeout
mechanism is disabled. The default is 270 seconds.
An integer (1..3600) that specifies the number of seconds that your Telnet or FTP session
can be idle before it will be automatically disconnected. The default is 900 seconds. 0
telnet-timeout:
disables the timeout. CAUTION: small values, such as 1–5, may effectively disable the use
of Telnet. A Telnet session may terminate before any changes can be made.
Enables or disables the
ews-config:
Specifies the maximum segment size (MSS) that the print server will advertise for use when
communicating with local subnets (Ethernet MSS=1460 bytes or more) or remote subnets
(MSS=536 bytes):
tcp-mss:
MSS affects performance by helping to prevent IP fragmentation that may result in data
retransmission.
Specifies the maximum segment life (MSL) in seconds. The range is 5–120 seconds. The
tcp-msl:
default is 15 seconds.
Enables or disables incoming Telnet connections:
telnet-config:
and power cycle the print server, or cold-reset the print server to factory default settings.)
SNMP parameters for TFTP
TFTP Parameter
snmp-config:
get-community-name:
set-community-name:
auth-trap:
0 Disables.
1 (default) Enables.
embedded web server
0 Disables.
1 (default) Enables.
0 (default) All networks are assumed to be local (Ethernet MSS=1460 bytes or more).
1 Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes for remote networks.
2 All networks are assumed to be remote (MSS=536 bytes), except the local subnet.
0 Disallows them. (To regain access, change the setting in the TFTP configuration file
1 Allows them.
Enables or disables SNMP operation on the print server:
0 Disables.
1 (default) Enables.
Specifies a password for SNMP GetRequests sent to the print server. This password is
optional. If a user-specified get community name is set, the print server will respond to
either a user-specified community name or the factory-default. The community name
must be ASCII characters. The maximum length is 255 characters.
Specifies a password that determines which SNMP SetRequests (control functions) the
print server will respond to. The community name of an incoming SNMP SetRequest
must match the print server's set community name for the print server to respond.
SetRequests must come from hosts that are configured in the print server's host access
list. Community names must be ASCII characters. The maximum length is 255
characters.
Configures the print server to send (on) or not send (off) SNMP authentication traps.
The default is on. Authentication traps indicate that an SNMP request was received,
but the community name check failed.
to view or change configuration values:
Description