HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 131

53
BAD BOOTP TAG
SIZE
54
BOOTP/RARP IN
PROGRESS
55
BOOTP/DHCP IN
PROGRESS
56
DHCP NAK
57
UNABLE TO
CONNECT DHCP
SVR
58
POSTSCRIPT
MODE NOT
SELECTED
59
INCOMPLETE
F/W- MUST
DOWNLOAD
5A
TURN PRINTER
OFF/ON
83
DISCONNECTING
FROM SERVER
Back to Top
End of troubleshooting
If you have not been able to correct your print server problem using this troubleshooting
procedure, you will need to contact HP technical support for further assistance. Click on the button
below for details.
The tagsize in a vendor specific field in the BOOTP reply is either 0, or
greater than the remaining number of unprocessed bytes in the vendor
specified area.
The print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
The print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected
any errors.
The print server received a negative acknowledgment message from the
DHCP server in response to a configuration request.
The print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the
DHCP server.
If an infinite lease was assigned, the print server will use the IP address
of the most recent DHCP server used, but operation may be degraded
until a DHCP server responds.
The printer does not support AppleTalk or AppleTalk extensions.
Firmware download message. Currently downloading firmware to the
print server, or the download did not complete properly.
Firmware download message. Download of firmware is complete.
Power cycle the print server.
The server has been shut down because of a configuration change or
reset request. This message automatically clears after a few seconds,
unless the printer is off line, is in an error state, or is servicing another
I/O port or another network protocol.
©2000, 2001 Hewlett-Packard Company