HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 79

Communication
Sets the highest level of USB communication to be used when
Mode
the print server tries to establish the best level with the printer.
Note that the current USB mode being used is reported on the
Jetdirect configuration page.
Status
Sets the Page Description Language (PDL), the printer language
(Configuration)
of the data sent to the printer, for the configuration (test) page.
Page Language
Settings are:
Other Settings
LPD Queues tab
Miscellaneous
Networking
Click on the
Configuration
page (in the
enter the desired value and click
LPD Queues
The LPD Queues parameters govern the operation of printing under the LPD (line
printer daemon) application. (For additional information on LPD printing and use of
the LPD queues, refer to the section on
queues are available under LPD. Four of these queues are configured automatically
and their parameters can not be changed. The remaining six queues can be defined by
the user.
The six user-definable queues can be set up with character strings—such as job
Automatic
is the default setting, allowing the print server
to set the highest level it determines to function. The
highest level it attempts is 1284.4, a IEEE standard
protocol, a mode for printers and multi-function (All-in
One) devices that allows multiple channels of
simultaneous print, scan, and status communication.
Otherwise it attempts, in turn, one of the other modes, as
listed below. This parameter is used to limit the highest
setting to one of those below.
MLC
is the next lower level, an HP-proprietary protocol for
Multiple Logical Channels, a mode for printers and
multi-function (All-in One) devices that allows multiple
channels of simultaneous print, scan, and status
communication.
Bidirectional
is the next lower level, two-way printer
communication, sending print data to the printing device
and returning status information from the printing device.
Unidirectional
is the lowest level, one-way printer
communication from the computer to printing device.
PCL ASCII
,
tab
tab at the top of the web page. In the left column of the
Other Settings
list, select
[Apply]
.
LPD
(How to see the configuration
PostScript HPGL2
, , and
. To assign a parameter setting,
Printing.) Ten different named print
page)
.