HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 29

The installation sequence for DHCP or BOOTP/TFTP setup
1. Set up the DHCP or BOOTP service.
2. Install the hardware; power on the print server.
procedure.
3. For Windows computers, run the Install Network Printer wizard
on each client to load driver and set up the print path. Return to
the initial screen for this CD, and select the
the Install Network Printer wizard.
To configure the device, the client broadcasts a boot request packet
containing at least the hardware address of the device (HP Jetdirect
print server hardware address). The server answers with a boot reply
packet containing the information the device needs to configure.
Syslog Server
A syslog server is a system on the network (typically a UNIX system)
that can receive and log syslog messages from other devices on the
network. Syslog messages allow administrators to monitor status or
troubleshoot network devices.
A syslog server requires software that provides syslog capabilities
running on the server. UNIX systems provide a daemon, syslogd, that
monitors User Datagram Protocol (UDP) port 514 for incoming
messages. The messages are processed depending their priority and on
how syslogd is set up to operate.
You can configure the HP Jetdirect print server with the syslog
server's IP address. When a syslog server is configured, both the HP
Jetdirect print server and attached device (such as a printer or mopier)
can send syslog messages using UDP.
The syslog server may not receive all syslog events from the HP
Jetdirect print server:
UDP does not guarantee delivery of messages.
The HP Jetdirect print server attempts to eliminate duplicate
messages (to minimize unnecessary network traffic).
The volume of messages sent by the HP Jetdirect print server is
configurable.
Methods to configure HP Jetdirect syslog parameters include BOOTP,
DHCP, Telnet, the
Selected syslog parameters on the HP Jetdirect print server:
embedded web server, and management software.
Refer to procedure.
Refer to
[Install]
button for