User Interface Options - HP Jetdirect 310x - Print Server For Fast Ethernet User Manual

Procedure
To set configuration parameters, you must set up a Telnet connection from your system to the HP Jetdirect print server.
1. Type the following at the DOS prompt:
telnet <IP address>
where:
<IP address> may be the print server's assigned address from BOOTP, RARP,
DHCP, from the printer control panel, or the default IP address. The default IP address is
192.0.0.192. The IP address is listed on the
2. A connection to the print server will be displayed. If the server responds with "connected to IP address",
press [Enter] twice to make sure that the Telnet connection is initialized.
3. If prompted for a user name and password, enter the correct values.
By default, the Telnet interface does not require a user name or password. If an administrative password has been
set, you will be prompted for a user name and this password before you can enter and save Telnet commands.
4. By default, a command line interface is provided. For a list of supported commands and parameters, see the list of
Telnet commands and parameters
instead, enter Menu. For more information, see

User interface options

The print server provides two interface options to enter Telnet commands,
and menu.
Command line interface (default) procedure
Use the following procedure for Telnet's command line interface to change parameters:
1. At the Telnet prompt ">" enter:
<parameter>: <value>
where:
<parameter> is the string for the configuration parameter you are defining. Command
strings are found in the first column of the
Jetdirect configuration
at the end of this section. To configure parameters using the menu interface
user interface options
Telnet commands and parameters
page.
below.
command line interface, which is the default,
list at the end