HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 41

TFTP Parameter
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server:
appletalk:
DLC/LLC parameters for TFTP [not for 175x]
TFTP Parameter
Enables or disables DLC/LLC protocol operation on the print server:
[not for 175x]
dlc/llc:
Other parameters for TFTP
TFTP Parameter
scan-config:
scan-idle-timeout:
scan-email-config:
MFP-config:
usb-mode:
usb-statpg-lang:
Support parameters for TFTP
0 Disables.
1 (default) Enables.
0 Disables.
1 (default) Enables.
Enables or disables the web scanning feature in the embedded web server, when
connected to a supported device:
0 Disables.
1 (default) Enables.
Specifies the number of seconds (1–3600) that an idle scan connection is allowed to
remain open. 0 disables the timeout. The default is 300 seconds.
Enables or disables the scan-to-email feature in the embedded web server, when
connected to a supported device:
0 Disables.
1 (default) Enables.
Enables or disables print server support of the client software provided with your
multifunction peripheral (MFP) or All-In-One:
0 (default) Disables (allows printing only).
1 Enables (allows printing, scanning, etc.).
Specifies the communication mode over the USB port on the print server:
Auto (default) Automatically negotiates and sets the the highest
communication mode possible for the attached printer or device.
MLC (Multiple Logical Channels) An HP-proprietary communication mode
that allows multiple channels of simultaneous print, scan, and status
communications.
BIDIR A standard connection that supports bi-directional communications
between the printer and print server. The print server sends print data and
receives status from the printer.
UNIDIR A standard connection in which data is transferred in one
direction only (to the printer).
Specifies the page description language (PDL) used by the print server to send the
Jetdirect configuration page to the printer:
Auto (default) The language is auto-detected when the print server is
powered on or after a cold reset to factory defaults.
PCL Hewlett-Packard Printer Control Language
ASCII Standard ASCII characters
HPGL2 Hewlett-Packard Graphics Language (v2)
PS Adobe PostScript language
Description
Description
Description