HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 119

The host name configured on the print server. It may be truncated.
Host Name
The Internet Protocol (IP) address assigned to the print server. This is a
IP Address
required entry for its operation on a TCP/IP network. During initialization, a
temporary value 0.0.0.0 is displayed. After two minutes, a default IP
address 192.0.0.192 is assigned, which may not be a valid IP address
for your network.
The IP subnet mask configured on the print server. During initialization, a
Subnet
temporary value 0.0.0.0 is displayed. Depending on configuration
Mask
parameters, the print server may automatically assign a usable default value.
The IP address of the gateway used when sending packets off the local
Default
network. Only one default gateway may be configured. During initialization, a
Gateway
temporary value 0.0.0.0 is displayed. If not provided, the IP address of
the print server is used.
Identifies how the print server obtained its IP configuration.
Config By
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It
BOOTP
specifies the IP address of the system that responds to the print server's
Server
or request for automatic TCP/IP configuration over the network.
DHCP
Server
or
RARP
Server
Not Specified no host name was specified in a BOOTP response
or TFTP configuration file.
NPIxxxxxx the default name is NPIxxxxxx, where xxxxxx
represents the last six digits of the LAN hardware (MAC) address.
Not Specified an IP address is not assigned or the value is zero.
Not Specified a subnet mask is not configured.
Not Specified a default gateway is not configured.
Not Configured
parameters. Verify that TCP/IP is enabled, or check for error status.
automatic configuration via a BOOTP server.
BOOTP
automatic configuration via a BOOTP server and
BOOTP/TFTP
TFTP configuration file.
automatic configuration via a DHCP server.
DHCP
automatic configuration via a DHCP server and TFTP
DHCP/TFTP
configuration file.
automatic configuration via the Reverse Address Resolution
RARP
Protocol.
User Specified
control panel, HP Web Jetadmin, embedded web server, or other
method.
the default IP address was assigned. This address
Default IP
may not be a valid address for your network.
Not Specified the configuration server's IP address could not be
determined or was set to zero in the response packet.
the print server was not configured with IP
manual configuration via Telnet, the printer's