Xerox 6030 User Manual page 144

When the SCAN SYSTEM is
set to exit to the front, the
document is difficult to
remove from the SCAN
SYSTEM
Width detection failed when
scanning trans parent
documents. Width sensors
in most cases will not detect
transparent documents.
Not Ready Media Jam
The SCAN SYSTEM does
not position the document
correctly before scanning.
Image quality
Vertical lines and streaks are
visible in the copy.
Visible document edges on
the copy.
Dark spots or smudges
appear on the copy.
The copy image is too light.
The image density on the
copy varies from light to
dark.
Copies made in Photo mode
have geometric patterns.
Fine lines on the original do
not appear on the copy when
the image size is reduced.
142 Problem solving
SYSTEM Control
Raise the Thick Document Lever to
release the document. Be sure to lower
the Thick Document Lever before
making the next copy/scan.
Enter the document width.
Refer to Cleaning the Platen Glass and
Document Drive Rolls. Wipe the
Document Feed Tray with anti-static
fluid.
Ensure that you are inserting the
document correctly.
Center the document between the
marks on the Document Feed Tray.
Smoothly insert the document into the
feed mechanism so that the lead edge
of the document is against the rollers
before the SCAN SYSTEM begins to
stage the document.
Clean the Platen Glass.
Try a lighter Contrast setting.
Clean the Platen Glass.
Adjust the Copy setting for best image
quality.
Rotate the original 90 degrees.
Set the Original, Type to Normal and
the Background Suppression to Off.
Enable the LINE MODE LINE
PRESERVATION option. See
"Imaging" in the "Main Menu" section
Set the SCAN SYSTEM
to exit to the rear. See
"SCAN SYSTEM
Control" in the "Main
Menu" section for more
information.
Turn AUTOWIDTH off
and refer to "Scan
System Control" in the
Main Menu
If the document is
folded, worn or
damaged, use a
document carrier or try
feeding a different edge.
Check the operation of
the optical paper
sensors. See "Sensors"
in the "Main Menu"
section for more
information.
Inspect the original and
clean it if necessary.
Rotate the original 90
degrees.
Adjust the Copy setting
for best image quality.
Set Original, Type to
Line and Background
Suppression off.
Adjust the Copy setting
for best image quality.
DocuWide 6030/6050
For thick
documents,
set the
Thick
Document
Lever to its
next higher
setting.
Thick
documents
may require
operator
assistance.
Adjust the
Copy
setting for
best image
quality.
Try a lighter
Contrast
setting.