Scan System Control - Xerox 6030 User Manual

SCAN SYSTEM
CONTROL
100 Main Menu
POWER SAVER DELAY (0
5. Use the numeric keypad to enter the power saver value. The
valid value range is 0 to 4 hours. The factory default is 3 hours.
6. Press the Enter key to confirm the value.
7. Press the Exit key to return to the CONFIGURATION menu
screen.
The SCANNER CONTROL option of the CONFIGURATION menu allows
you to set the options for how the SCAN SYSTEM starts and finishes a
scan. It contains the following features:
AUTOSCAN - Tells the SCAN SYSTEM either to start the scan
automatically when the document is inserted (ENABLED), or to
wait until the Start key is pressed (DISABLED). ENABLED is
the factory default setting.
DOCUMENT RETURN - Tells the SCAN SYSTEM, after the
scan, either to return the document to the front of the SCAN
SYSTEM (FRONT), or to drop the document from the rear of the
SCAN SYSTEM into the catch tray (REAR). REAR is the factory
default setting.
NOTE: Refer to Controlling the Scan for additional information.
MODE:
MANUAL WIDTH - The user must enter the document width
and very carefully center the document. In this mode the
document will be prescanned.
AUTOWIDTH - Enables the automatic detection of the width
of the document. . In this mode the document will be
prescanned.
AUTOWIDTH/AUTOCENTER - Enables the automatic
centering of the image and automatic width detection. This
selection is the default. . In this mode the document will be
prescanned.
PRODUCTIVITY: This feature does not use AUTOCENTER
requiring the operator to manually align the document within
the media guidelines on the Feed-in Tray. The width sensors
eliminate the need for a prescan thereby increasing the
overall throughput of the system resulting in higher
productivity. When this feature is used the operator must
select the media series, ANSI, ARCH, ISO A, ISO B JIS B
and CUSTOM etc since the number of sensors provided can
not monitor every media type.
To use the MODE: PRODUCTIVITY: CUSTOM the custom
POWER SAVER
4 HR): 3
DocuWide 6030/6050