Xerox 6030 User Manual page 11

Xerox 6030/6050 Wide Format Copy System
A: Standard Stacker
B: Document Exit Slot
C: Power On/Off switch
NOTE: Components shown above with the exception of the Standard
Organizer are also available on all WIDE FORMAT SCAN SYSTEMs
A. Standard Stacker
The Stacker is located at the rear of the SCAN SYSTEM. When the
AUTORETURN feature is set to REAR, documents exit the SCAN
SYSTEM onto the Stacker. The Stacker can be adjusted to any one of
four positions by raising or lowering it. The height of the Stacker should
be adjusted to accommodate the document being scanned. It has two
extensions at its end that can be pulled out to accommodate longer
documents (up to size E or A0). When scanning most common weight
(20 lb, 80gsm) documents, move the Stacker to the 2nd rung from the
bottom.
NOTE: All thick documents and documents over 36 inches (914 mm)
exit from the rear of the Scan System (regardless of the AUTORETURN
setting). When scanning thick documents, the Stacker must be set to the
lowest position for optimum performance.
B. Document Exit Slot
When the DOCUMENT RETURN feature is set to REAR, documents exit
the Scan System through this slot and are delivered to the rear Stacker.
C. Power On/Off Switch
This switch turns the Scan System on and off. Press this switch to the
on (I) position to turn on the Scan System and to the off (O) position to
turn off the Scan System.
D. The Power Cord supplies power to the Scan System. Plug one end of
the cord into the Scan System and the other end into an electrical outlet.
E.Status LED
The digital status LED provides an indication of the condition of the Scan
System and communications with the AccXES Print Server. A P
displayed on the LED Display on the rear of the Scan System indicates
that the Scan System is operating normally and has established
communications with the AccXES Print Server.
F. IEEE 1394 Cable and Connector
The IEEE 1394 Cable is the communications link between the Scan
System and the AccXES Print Server. Plug one end of the cable into
either one of the IEEE 1394 connections at the rear of the Scan System.
Plug the other end into the IEEE 1394 connection on the AccXES Print
Server.
Getting to know the WIDE FORMAT COPY SYSTEM 9
D: Power Cord and Connector
E: Status Indicator LED
F: IEEE 1394 Cable and Connector