Scan System Warm-Up - Xerox 6030 User Manual

Xerox
6030/6050
Wide Format
Power Switch
Scan System Warm-
up
Xerox 6030/6050 Wide Format Copy System
When the SCAN SYSTEM is switched on, the fluorescent lamp
illuminates immediately. If the lamp does not illuminate, refer to the
"Problem solving" section of this guide.
The AccXES Print Server has its own power switch. When powering on,
first power on the Xerox 6030/6050 Wide Format and then power on the
AccXES Print Server. Refer to the 6030/6050 Wide Format Printer User
guide for additional information on powering on the 6030/6050 Printer.
The Scan System requires about 45 seconds to warm up and initialize
after you power on the Xerox 6030/6050 Wide Format. Once the
initialization is complete, the READY screen is displayed. Below is an
example of the READY screen.
READY TO COPY
INSERT DOCUMENT
AUTO
You can now insert a document into the Document Feed Tray of the
SCAN SYSTEM. The SCAN SYSTEM will then transport the document
to the starting position. This transportation of the document is called
staging.
If you cannot insert a document into the feed mechanism and achieve
staging after approximately 4 minutes, refer to the "Problem solving"
section of this guide.
Getting to know the WIDE FORMAT COPY SYSTEM 29
AccXES
Print Server
Power
Switch
100.0 %
1