Batch Key - Xerox 6030 User Manual

72 Special features keys
7. Enter the number of copies desired and press the Start key.
The Printer prints the number of sets requested.
NOTE: In COLLATION FORWARD only, an extra set is made as a check
plots set.
After the printing of the set, the set can be recalled, the values changed
again, and the set reprinted using the new values. To recall the set, refer
to "Store/Recall key" in the "Special features key" section of this manual
for further information.

Batch key

The Batch feature allows you to improve copy speed by enabling Batch
Mode processing of several documents on the SCAN SYSTEM. When
Batch Mode processing is enabled, the SCAN SYSTEM collects prescan
information for just the first document inserted into the SCAN SYSTEM.
Prescan information on subsequent documents in the set is not
collected. The subsequent documents will be scanned using the
information collected on the first document. Eliminating the collection of
this information increases overall copy speed.
To enable Batch Mode processing:
1. Press the Batch key. The Batch indicator lamp will begin
flashing.
2. Insert the first original into the SCAN SYSTEM. The SCAN
SYSTEM scans the original and the screen shown below is
displayed.
WIDTH FOUND FOR SET IS XX.X
INPUT ANOTHER WIDTH OR
PRESS ENTER TO ACCEPT
3. Do one of the following:
Use the numeric keypad to enter the width of the set and press the Enter
key to accept the value.
Press the Enter key to accept the width detected by the WIDE FORMAT
COPY SYSTEM.
The Batch indicator lamp becomes steady and remains so until batch
mode is disabled.
4. When the last document in the set has been scanned, press the
Batch key to disable batch mode. The Batch indicator lamp is
extinguished.
NOTE: When Batch mode is ENABLED, the AUTOCENTER feature is
temporarily disabled. Be careful to manually center each document that
is inserted into the SCAN SYSTEM
DocuWide 6030/6050