Installing a blade handle
Use these instructions for information about how install a blade handle.
To install a blade handle, complete the following steps:
1. Orient the blade server with the cover side down and the bezel towards you.
2. Locate where you will be installing the blade handle.
3. Orient the blade handle so that the blue release latch is towards the middle of
4. Align the hole in the blade handle with the hole on the blade server where the
5. Use a screwdriver to install the screw that secures the blade handle to blade
6. Install the blade server into the BladeCenter unit (see "Installing the blade
Removing the battery
Use this information to remove the battery from the blade server.
To remove the battery, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove the expansion unit (see
5. Locate the battery on the system board.
58
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
Note: The left handle and right handle are not the same part. To identify where
the blade handle should be installed, see the illustration and parts listing
provided in Chapter 4, "Parts listing," on page 41.
the blade server.
handle will be installed.
server. It is recommended to install the screw that was removed when the
blade handle was removed.
server in a BladeCenter unit" on page 53).
page 49.
the blade server from the BladeCenter unit" on page 52 for instructions).
55 for instructions).
"Removing an optional expansion unit" on page 84).