Installing A Usb Flash Key - IBM 7870B4U Service Manual

7. Using your fingers, pull the USB Flash key out of the connector.
8. If you are instructed to return the USB Flash key, follow all packaging

Installing a USB Flash key

Use these instructions to install a USB Flash key in the blade server.
The following illustration shows the installation of the USB Flash key.
To install a USB module, complete the following steps:
1. If a CIOv expansion card is installed, remove the expansion card (see
2. Locate the USB connector on the blade server (see "Blade server connectors" on
3. Touch the static-protective package that contains the USB Flash key to any
4. Orient the connector on the USB Flash key with the USB connector on the
5. Use your fingers to push the USB Flash key into the USB connector on the
6. If a CIOv expansion card was removed during the install process, install the
7. Install the cover onto the blade server (see "Closing the blade server cover" on
8. Install the blade server into the BladeCenter unit (see "Installing the blade
70
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
instructions, and use any packaging materials for shipping that are supplied to
you.
"Removing a CIOv-form-factor expansion card" on page 71).
page 15).
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component in the rack in which you are installing
the USB module for at least two seconds; then, remove the USB module from
its package.
blade server.
blade server.
expansion card (see "Installing a CIOv-form-factor expansion card" on page
75).
page 56).
server in a BladeCenter unit" on page 53).