Table of Contents
Advertisement
Installing the DPI blade in a BladeCenter unit
The following illustration shows how to install a DPI blade into a BladeCenter H or
HT unit. The appearance of your BladeCenter unit might be different. See the
documentation for your BladeCenter unit for additional information.
To install a DPI blade in a BladeCenter unit, complete the following steps.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
1. Read the safety information that begins on page v, "Installation guidelines" on
2. Select the bay for the DPI blade.
28
IBM BladeCenter PN41 Type 3020 Deep Packet Inspection Blade: Problem Determination and Service Guide
page 25, and "Handling static-sensitive devices" on page 26, and read the
safety statements in the BladeCenter unit documentation.
Notes:
v If you reinstall a DPI blade into the same blade bay from which you removed
it, the DPI blade automatically rebinds with the host blade server. Some DPI
blade configuration information and update options are established according
to bay number. Reinstalling a DPI blade into a different bay from which it was
removed will required you to bind the DPI blade to the host blade server.
v When any blade server, DPI blade, or other device is in blade bays 7 through
14 (in a BladeCenter H unit) or 7 through 12 (in a BladeCenter HT unit),
power modules must be installed in all four power-module bays. For
additional information, see the Installation and User's Guide that comes with
the BladeCenter unit.
v To help ensure proper cooling, performance, and system reliability, make sure
that each blade bay on the front of the BladeCenter unit contains a blade
Advertisement
Table of Contents
