Removing a hot-swap storage drive
Use this information to remove a hot-swap storage drive.
The blade server has two SAS hot-swap storage bays for installing or removing
hot-swap storage devices, such as a SAS storage drive. To remove a hot-swap hard
disk drive or drive filler, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. Press the release latch (orange) on the storage drive to release the drive handle.
3. Pull the release handle to remove the drive from the storage bay.
4. If you are instructed to return the storage drive, follow all packaging
62
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
page 49.
instructions, and use any packaging materials for shipping that are supplied to
you.