Table of Contents
Advertisement
Checkout procedure
Use this information to perform the checkout procedure for the blade server.
The checkout procedure is the sequence of tasks that you should follow to
diagnose a problem in the blade server.
About the checkout procedure
Use this information to run diagnostics, locate error codes, and identify device
errors for the blade server.
Before you perform the checkout procedure for diagnosing hardware problems,
review the following information:
v Read "Safety" on page v and "Installation guidelines" on page 49.
v The diagnostic programs provide the primary methods of testing the major
v When you run the diagnostic programs, a single problem might cause more than
v If the blade server is halted and a POST error code is displayed, see "POST error
v For intermittent problems, check the error log; see "Error logs" on page 103 and
v If no LEDs are lit on the blade server front panel, verify the blade server status
v If device errors occur, see "Troubleshooting tables" on page 166.
Performing the checkout procedure
Use this information to perform the checkout procedure for the blade server.
To perform the checkout procedure, complete the following steps:
1. If the blade server is running, turn off the blade server.
2. Turn on the blade server. Make sure that the blade server has control of the
3. Record any POST error messages that are displayed on the monitor. If an error
4. Check the control panel blade-error LED; if it is lit, check the light path
5. Check for the following results:
components of the blade server. If you are not sure whether a problem is caused
by the hardware or by the software, you can use the diagnostic programs to
confirm that the hardware is working correctly.
one error message. When this happens, correct the cause of the first error
message. The other error messages usually will not occur the next time you run
the diagnostic programs.
codes" on page 146. If the blade server is halted and no error message is
displayed, see "Troubleshooting tables" on page 166 and "Solving undetermined
problems" on page 232.
"Dynamic system analysis diagnostic programs and messages" on page 189.
and errors in the Advanced-Management-Module Web interface; also see
"Solving undetermined problems" on page 232.
video (the LED on the keyboard/video/mouse button is lit). If the blade server
does not start, see "Troubleshooting tables" on page 166.
is displayed, look up the first error in the "POST error codes" on page 146.
diagnostics LEDs (see "Light path diagnostics" on page 183).
v Successful completion of POST, indicated by beginning the startup of the
operating system.
v Successful completion of startup, indicated by a readable display of the
operating-system desktop.
165
Chapter 6. Diagnostics
Advertisement
Table of Contents
