IBM 7870B4U Service Manual page 147

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are CRUs and which components
are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error Code Type
0x806F0507 Error
0x806F0507 Error
Error Message
Group 4, processor (All CPUs)
configuration error
Group 4, processor (CPU X
Status) configuration error [Note
X=1,2]
Action
1. Remove the blade server and ensure the
processors are installed correctly (see "Installing a
microprocessor and heat sink" on page 94).
2. Verify that the system is running the latest UEFI
firmware (see "Firmware updates" on page 34).
3. Run the Setup utility (see "Using the Setup
utility" on page 21).
a. Make sure that both processors are displayed
by the system.
b. Load the default settings.
c. Go to the System Settings menu and make
sure the processor is enabled.
1. Remove the blade server and ensure the
processors are installed correctly (see "Installing a
microprocessor and heat sink" on page 94).
2. Verify that the system is running the latest UEFI
firmware (see "Firmware updates" on page 34).
3. Run the Setup utility (see "Using the Setup
utility" on page 21).
a. Make sure that both processors are displayed
by the system.
b. Load the default settings.
c. Go to the System Settings menu and make
sure the processor is enabled.
133
Chapter 6. Diagnostics