IBM 7870B4U Service Manual page 53

5. Click Next. The installation wizard opens and guides you through the
installation.
Note: The Windows installation disk might be required.
LAN over USB Windows Driver Installation
Use this information to install the LAN over USB driver for Windows.
When you install Windows, there will be an unknown RNDIS device in the device
manager. IBM provides a Windows INF file that identifies this device. The signed
version of the INF is included in all of the Windows versions of the IMM, UEFI,
and DSA update packages. Perform the following steps to install
ibm_rndis_server_os.inf.
Note: These steps only need to be performed if the server is running a Windows
operating system and the ibm_rndis_server_os.inf file has not been previously
installed. The file needs to be installed only once. It is required by Windows
operating systems to detect and use the LAN over USB functionality.
1. Obtain a Windows version of the IMM, server firmware, and DSA update
package (see "Firmware updates" on page 34 for more information).
2. Extract the ibm_rndis_server_os.inf and device.cat files from the firmware
update package and copy them to the \WINDOWS\inf subdirectory.
3. For Windows 2003: Install the ibm_rndis_server_os.inf file by right-clicking
on the file and selecting Install. This generates a PNF file of the same name in
\WINDOWS\inf.
For Windows 2008: Go to Computer Management, then Device Manager and
find the RNDIS Device. Select Properties > Driver > Reinstall driver. Point
the server to the \Windows\inf directory where it can find the
ibm_rndis_server_os.inf file and install the device.
4. Go to Computer Management then Device Manager and right-click on
Network adapters and select Scan for hardware changes. A small pop-up
confirms that the Ethernet device is found and installed. The New Hardware
Wizard starts automatically.
5. When you are prompted with the question, "Can Windows connect to
Windows Update to search for software?", select No, not this time. Click Next
to continue.
6. When you are prompted with the question, "What do you want the wizard to
do?", select Install from a list or specific location (Advanced). Click Next to
continue.
7. When you are prompted with the statement, "Please choose your search and
installation options", select Don't search. I will choose the driver to install.
Click Next to continue.
8. When you are prompted with the statement, "Select a hardware type, and
then click Next", select Network adapters. Click Next to continue.
9. You are prompted with the statement, "Completing the Found New Hardware
Wizard". Click Finish.
Note: A new local area connection appears and might state, "This connection
has limited or no connectivity". Ignore this message.
10. Go back to the Device Manager. IBM USB Remote NDIS Network Device
appears under Network Adapters.
Chapter 3. Configuring the blade server
39