IBM 7870B4U Service Manual page 44

30
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
[access_method]
The access method that you select to use from the following methods:
v Online authenticated LAN access, type the command:
[host &ltimm_internal_ip>] [user &ltimm_user_id>][password
<imm_password>]
Where:
imm_internal_ip
The IMM internal LAN/USB IP address. The default value is
169.254.95.118.
imm_user_id
The IMM account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
Note: If you do not specify any of these parameters, ASU will use the
default values. When the default values are used and ASU is unable to access
the IMM using the online authenticated LAN access method, ASU will
automatically use the following unauthenticated KCS access method.
The following commands are examples of using the userid and password
default values and not using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName <m/t_model> --user
<imm_user_id> --password <imm_password>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum <s/n> --user <imm_user_id>
--password <imm_password>
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag <asset_tag> --user
<imm_user_id> --password <imm_password>
Examples that do use the userid and password default values:asu set
SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> asu set
SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> asu set
SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
v Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this
access method.
The KCS access method uses the IPMI/KCS interface. This method requires
that the IPMI driver be installed. Some operating systems have the IPMI
driver installed by default. ASU provides the corresponding mapping layer.
See the Advanced Settings Utility Users Guide at http://www-947.ibm.com/
systems/support/supportsite.wss/docdisplay?brandind=5000008
&lndocid=MIGR-55021 for more details.
The following commands are examples of using the userid and password
default values and not using the default values:
Examples that do not use the userid and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName &ltm/t_model>
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum &lt;s/n>
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag &ltasset_tag>