Table of Contents
Advertisement
10. Reinstall the bezel assembly on the BladeCenter T unit (BladeCenter T unit
If you have changed the configuration of the blade server or if you are installing a
different blade server from the one that you removed, you must configure the
blade server through the Setup utility, and you might have to install the blade
server operating system. Detailed information about these tasks is available in the
Installation and User's Guide.
Removing and replacing Tier 1 customer replaceable units (CRUs)
Use this information for removing and replacing Tier 1 CRUs.
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
Removing the blade server cover
Use these instructions to open the blade server cover.
The following illustration shows how to open the cover on the blade server.
To open the blade server cover, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Press the blade server cover release on each side of the blade server or
Important: Do not place the label on the blade server or in any way block the
ventilation holes on the blade server.
only). For detailed instructions for reinstalling the bezel assembly, see the
Installation and User's Guide that comes with the BladeCenter T unit.
page 49.
the blade server from the BladeCenter unit" on page 52 for instructions).
side up.
expansion unit and lift the cover open, as shown in the illustration.
Chapter 5. Removing and replacing blade server components
55
Advertisement
Table of Contents
