Table of Contents
Advertisement
6. Locate the CIOv expansion connector (see "Blade server connectors" on page
7. Using your fingers, move the retaining clips away from the CIOv card; then, lift
Removing a horizontal-compact-form-factor expansion card
Use these instructions to remove a compact-form-factor expansion card from the
blade server.
The following illustration shows how to remove a horizontal-compact-form-factor
(CFFh) expansion card.
To remove a CFFh expansion card, complete the following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. Locate the CFFh expansion card. The CFFh is installed into the blade expansion
6. Use your fingers to hold the edge of the CFFh expansion card where it
7. Pull the card away from the expansion-card standoff.
72
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
15).
the card out of the connector.
page 49.
the blade server from the BladeCenter unit" on page 52 for instructions).
55 for instructions).
connector (see "Blade server connectors" on page 15).
connects to the blade expansion connector; then, lift up on the card.
Advertisement
Table of Contents
