Configure Snmp Agent Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

To configure SNMP trap recipients:
1. At the Hardware View page for the selected switch, choose Configure >
Figure 22: Configure SNMP Agent dialog box
2. To enable transmission of trap messages to configured SNMP management
Edge Switch 2/24 Installation Guide
SNMP Agent. The Configure SNMP Agent dialog box displays
a. For each trap recipient to be configured, enter a community name of 64 or
fewer alphanumeric characters in the associated Community Name field.
The community name is incorporated in SNMP trap messages to ensure
against unauthorized viewing or use.
b. Click the check box in the Write Authorization column to enable or
disable write authorization for the trap recipient (default is disabled). A
check mark in the box indicates write authorization is enabled. When the
feature is enabled, a management workstation user can change the HAFM
appliance's sysContact, sysName, and sysLocation SNMP
variables.
c. Enter the IP address or DNS host name of the trap recipient (SNMP
management workstation) in the associated Trap Recipient field. Use 32
or fewer alphanumeric characters. It is recommended that the IP address
be used.
d. The default user datagram protocol (UDP) port number for trap recipients
is 162. Enter a decimal port number in the associated UDP Port
Number field to override the default.
workstations, click Enable Authorization Traps. A check mark displays in
the box when transmission is enabled
Installing and Configuring the Edge Switch 2/24
(Figure 23).
(Figure 22).
77