Cli: Management Interface Wizard - HP ProCurve 2910al Access Security Manual

Security Overview
Getting Started with Access Security
Current values are
shown in brackets
(Password entries
must be entered
twice and will
appear as asterisks.)
Summary of current
settings (displayed
after last wizard
option has been set)
To save these settings, press [
To cancel any changes, type [n] (for no), then press [
Figure 1-1. Example of Management Interface Wizard Configuration
1-12

CLI: Management Interface Wizard

To configure security settings using the CLI wizard, follow the steps below:
At the command prompt, type setup mgmt-interfaces.
1.
The welcome banner appears and the first setup option is displayed
(Operator password). As you advance through the wizard, each setup
option displays the current value in brackets [ ] as shown in Figure 1-1.
Welcome to the Management Interface Setup Wizard
This wizard will help you with the initial setup of the various
management interfaces. The current values are shown in brack-
ets[]. Type in a new value, or press <Enter> to keep the cur-
rent value. Press CTRL-C at any time to quit the wizard without
saving any changes. Press ? for help.
Operator password
Manager password
Restrict SNMP access to SNMPv3 only
SNMPv2 community name
SNMPv2 Community access level
Telnet enabled
SSH enabled
Web management enabled
Restrict Web access to SSL
Timeout for ssh/telnet sessions
Operator password
Manager password
Restrict SNMP access to SNMPv3 only
SNMPv2 community name
SNMPv2 Community access level
Telnet enabled
SSH enabled
Web management enabled
Restrict Web access to SSL
Timeout for ssh/telnet sessions
Do you want to save these changes?
].
Enter
Enter
[not configured]:
Confirm password:
[*******]:
Confirm password:
[notpublic]:
[unrestricted]:
].
Type in a new
value to change a
setting, or press
<Enter> to keep
the current value.
[no]:
[yes]:
[no]:
[yes]:
[no]:
[0]:
:
:*******
:no
:notpublic
:unrestricted
:yes
:no
:yes
:no
:0
[yes]: