Enable or Disable the CLI
Perform this procedure to toggle (enable or disable) the state of the switch's
command line interface. To change the CLI state:
1. Choose Configure > Management > CLI to display the CLI tab
Figure 46: Management page—CLI tab
2. Perform one of the following steps as required:
Edge Switch 2/24 Installation Guide
— Click Enable to activate the CLI. The message "Your changes to
the CLI enable state have been successfully
activated" displays.
— Click Disable to deactivate the CLI. The message "Your changes to
the CLI enable state have been successfully
activated" displays.
Using the Embedded Web Server
(Figure
46).
111