Advanced Configuration; Configuring Advanced Ip Settings For Wireless Clients - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

This chapter describes how to configure the advanced features of your ProSafe 802.11a/g Dual
Band Wireless Access Point WAG302v2. The following list describes the advanced features:
• IP Settings: Use the AP as a DHCP server for wireless clients.
• Hotspot Settings: Capture and redirect all HTTP (TCP, port 80) requests.
• Wireless Settings: Configure advanced wireless LAN parameters and Quality of Service (QoS).
• Access Point Settings: Enable wireless bridging and repeating.
To get to these features, connect to the WAG302v2 as described in
Using Its Default IP Address" on page 2-7
heading.

Configuring Advanced IP Settings for Wireless Clients

The WAG302v2 can act as a DHCP server gateway for wireless clients. After you log in, click IP
Settings under the Advanced menu to view the Advanced IP Settings for Wireless Clients.
Figure 4-1

Advanced Configuration

Advanced Configuration
and click the desired link under the Advanced menu
v1.0, May 2006
Chapter 4
"Logging in to the WAG302v2
4-1