Wireless Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

Dual band wireless access point

Hide thumbs Also See for WAG302 - ProSafe Dual Band Wireless Access Point:

Reference manual (108 pages)

Table Of Contents

100

101

102

103

104

Table of Contents

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual

•

Untagged VLAN. You can use VLANS on the WAG302v2 to logically separate traffic

that is on the same physical network. VLAN tagging is always enabled so that the

WAG302v2 can process VLAN membership information.

•

By default all traffic on the WAG302v2 uses VLAN 1, which is the default untagged

VLAN. Therefore, all traffic is untagged until you change the untagged traffic VLAN ID

or the VLAN ID for a specific Security Profile. Check the Untagged VLAN check box to

transmit all frames on the specified VLAN as untagged. If you clear the box, all traffic is

tagged with a VLAN ID.

•

Time Zone. Select the Time Zone to match your location. If your location uses daylight

saving, check the box Adjust for Daylight Saving Time.

•

The Current Time, as used on the wireless access point, is displayed.

Note: You must have an Internet connection to get the current time.

•

NTP Server. Click Enable to use a network time protocol (NTP) server to synchronize the

clock in your access point, or click Disable if you do not want to use an NTP server.

•

Use Custom NTP Server. If you do not want to use the default NETGEAR NTP server,

click this box and enter the hostname or IP address of the NTP server to use.

3. Click Apply to save your settings.