Configuring Wireless Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Table C-6 Basic Setting (continued)s
Task
Set the Primary DNS Server
Set the Secondary DNS Server
Enable Spanning Tree Protocol
Disable Spanning Tree Protocol
Set the Management VLAN ID
Enable Untagged VLANs and set
the VLAN ID
Set the Time Zone
Enable the NTP Server
Disable the NTP Server
Use a custom NTP server
Use the default NTP server
Set the Hostname or IP Address
for the custom NTP server
Note: You can set a primary and
secondary NTP server.
View the Current Time

Configuring Wireless Settings

The commands in Table C-7
Table C-7 Wireless Settings
Task
Turn on the Radio
Turn off the Radio
C-8
Command
set host static-dns-1 <ip_address>
Example:
set host static-dns-1 10.10.3.10
set host static-dns-2 <ip_address>
set interface brvlan1 stp on
set interface brvlan1 stp off
set management vlan-id <1-4096>
set untagged-vlan untagged-vlan-id <1-4096>
set ntp timezone <timezone>
set ntp status up
set ntp status down
set ntp use-default-servers off
set ntp use-default-servers on
set ntp-servers [primary | secondary] server
[<hostname> | <ip_address
Example:
set ntp-serves primary ntp.foo.com
or
set ntp-servers primary server 192.168.1.10
date
correspond to the Wireless Settings page on the Web UI.
Command
set interface wlan0 status up
set interface wlan0 status down
v1.0, May 2006
>]
Command Line Reference