NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual page 54

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Table 3-1 describes the fields on the General Information page.
Table 3-1 General Information Fields
Field
Access Point Information
Access Point Name
(NetBIOS name)
MAC Address
Country/Region
Firmware Version
Access Point Mode
VLAN (802.1Q)
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings
Operating Mode
Channel/Frequency
Rogue AP Detection
Security Profiles
3-8
Description
The name of the access point, which you can configure.
The Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
The domain or region for which the wireless access point is licensed for
use. It may not be legal to operate this wireless access point in a region
other than one of those identified in this field.
The version of the firmware currently installed.
The operating mode of the WAG302v2: Access Point, Bridge, or
Repeater.
Indicates if VLAN support is enabled. The default is enabled.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
If the DHCP Client is enabled, the current IP address was obtained
from a DHCP server on your network. Disabled indicates a static IP
configuration.
Shows the IEEE 802.11 wireless operating mode.
The channel the wireless port uses. The default channel setting is 11.
For the frequencies used on each channel, see the resources listed in
Appendix A, "Related Documents.
Shows whether Rogue AP Detection is enabled.
For each Security Profile, the following information is displayed: Profile
Number, Profile Name, SSID, Security, VLAN, and Status.
v1.0, May 2006
Management and Information