Configuring Basic Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
helpful for viewing basic system information.
Table C-5 System Information
Task
View hardware information
View information about all interfaces
View information about the 802.11 radio
View information about the Security Profiles
View DNS settings

Configuring Basic Settings

The commands in Table C-6
Table C-6 Basic Setting s
Task
Set the Access Point Name
Set the Country / Region
Enable the DHCP Client
Disable the DHCP Client
Set a Static IP Address
Set a Subnet Mask
Set the Default Gateway
Command Line Reference
Command
get system
get interface
get radio
get vap
get host
correspond to the Basic Settings page on the Web UI.
Command
set host id <name>
Example:
set host id LAB_AP
set system country <2_letter_country_code>
Example:
set system country us
set management dhcp-client status up
set management dhcp-client status down
set interface brvlan1 static-ip <ip_address>
Example:
set interface brvlan1 static-ip 10.10.12.221
set interface brvlan1 static-mask <netmask>
Example:
set interface brvlan1 static-mask
255.255.255.0
set static-ip-route gateway <ip_address>
Example:
set static-ip-route gateway 10.10.12.1
v1.0, May 2006
C-7