NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual page 94

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
The commands in Table C-9
commands in this table show how to configure Security Profile 1, which is the default profile and
has a default profile name of NETGEAR.
Note: The commands in
on radio wlan0. To configure other security profiles, use vapx, where x is the VAP
ID associated with the security profile. To configure security profiles on the second
radio, use wlan1.
Table C-9 Security Profile Settings
Task
Enable a security profile
Disable a security profile
Set the security profile name
Set the SSID of the security
profile
Broadcast wireless network
name.
Do not broadcast wireless
network name.
Set Network Authentication to
Open System
Set Network Authentication to
Shared Key
Set the Data Encryption to 64-bit
WEP
Set the Data Encryption to 128-bit
WEP
Set the Key Type to ASCII
Set the Data Encryption to 152-bit
WEP
Set the Key Type to Hex:
C-10
correspond to the Security Profile Settings page on the Web UI. The
Table C-9 configure the default security profile, which is vap0
Command
set vap vap0 with radio wlan0 status up
set vap vap0 with radio wlan0 status down
set vap vap0 with radio wlan0 profile <name>
set interface wlan0vap0 ssid <ssid_name>
set bss wlan0bssvap0 ignore-broadcast-ssid off
set bss wlan0bssvap0 ignore-broadcast-ssid on
set interface wlan0 security plain-text
set interface wlan0 security static-wep
set interface wlan0vap0 wep-key-length 40
set interface wlan0vap0 wep-key-length 104
set interface wlan0vap0 wep-key-ascii yes
set interface wlan0vap0 wep-key-length 128
set interface wlan0vap0 wep-key-ascii no
v1.0, May 2006
Command Line Reference