Viewing General Information - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual

Viewing General Information

Table C-4 describes the commands you use to view some of the information that you see on the
General page of the Web UI.
Table C-4 General Information
Task
Access Point Information
View Access Point Name
View the MAC Address for the Access Point
View the Country/Region
View the Firmware Version for the Access
Point
View the Access Point Mode
View the Untagged VLAN ID
Current IP Settings
View the IP Address
View the Subnet Mask
View the Default Gateway IP address
View the DHCP Client status
Current Wireless Settings
View the Operating Mode
View the Channel / Frequency
View whether Rogue AP Detection is
enabled
View information about the Security Profiles
The commands in the following table do not correspond to a specific Web page, but they can be
C-6
Command
get host id
get interface brvlan1 mac
get system country
get system version
get interface brvlan1 type
get untagged-vlan
get interface brvlan1
get interface brvlan1
get ip-route gateway
get management dhcp-client status
get radio all mode
get radio all channel
get radio all ap-detection
get vap all detail
v1.0, May 2006
Command Line Reference