Access Control - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Table C-10 RADIUS Server Settings (continued)
Task
Set the Port Number of the Pri-
mary Accounting Server
Set the Shared Secret for the
Primary Accounting Server
Set the IP Address of the Sec-
ondary Accounting Server
Set the Port Number of the Sec-
ondary Accounting Server
Set the Shared Secret for the
Secondary Accounting Server

Access Control

The commands in Table C-11
Table C-11 Access Control Settings
Task
View a list of wireless clients
by MAC address
Create a list of clients to permit
access to the AP
Add a client to the Trusted
Wireless Stations list
Remove a client from the
Trusted Wireless Stations list
Disable MAC Access Control
(remove all clients from the
list)
Command Line Reference
Command
set radius-client primary-accounting-
port <port_number>
set radius-client primary-accounting-
key <value>
set radius-client secondary-accounting-
server <ip_address>
set radius-client secondary-accounting-
port <port_number>
set radius-client secondary-accounting-
key <value>
correspond to the Access Control page on the Web UI.
Command
get association station
set bss wlan0bssvap0 mac-acl-mode accept-list
add mac-acl wlan0bssvap0 mac <mac_address>
Example:
add mac-acl wlan0bssvap0 mac 00:01:02:03:04:05
add mac-acl wlan0bssvap0 mac 00:01:02:03:04:06
remove mac-acl wlan0bssvap0 mac <mac_address>
remove mac-acl all
v1.0, May 2006
C-13