Interface Naming Conventions - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Table C-1 Keyboard Shortcuts (continued)
Keyboard Shortcut
Ctrl-k
Ctrl-u
Ctrl-p
Up Arrow key
Ctrl-n
Down Arrow key
Ctrl-d

Interface Naming Conventions

Table C-2 describes the interface naming conventions for the WAG302v2.
Warning: The CLI uses specific interface names the Web UI does not use. Many get
and set commands require that you enter interface names.
Note: Use the get interface command to display common information on all
interfaces, including IP addresses.
Table C-2 Interface Naming Convention
Interface Description
brvlan1 The Internal bridge represents the internal interface for the access point. To Telnet or SSH
into the access point, use the IP address for this interface. The
brvlan1 interface consists of:
• eth0 (or vlan <vlanid> if you have VLANs configured)
• wlan0
• wlan1 (for the second radio)
brtrunk Internal bridge trunk interface.
Command Line Reference
Action on CLI
Remove characters starting from cursor location to end of the current line.
(Clears the current line from the cursor forward.)
Remove all characters before the cursor.
(Clears the current line from the cursor back to the CLI prompt.)
Display previous command in history.
(Ctrl-p and Ctrl-n let you cycle through a history of all executed commands like Up
and Down arrow keys typically do. Up/Down arrow keys also work for this.)
Display next command in history.
(Ctrl-p and Ctrl-n let you cycle through a history of all executed commands like Up
and Down arrow keys typically do. Up/Down arrow keys also work for this.)
Exit the CLI. (At a blank command prompt, typing Ctrl-d closes the CLI.)
(Typing Ctrl-d within command text also removes characters, one at a time, at cursor
location like Ctrl-h.)
v1.0, May 2006
C-3