Wireless Bridging And Repeating - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual

Wireless Bridging and Repeating

The WAG302v2 Wireless Access Point lets you build large bridged wireless networks.
Examples of wireless bridged configurations are:
• Point-to-Point Bridge. The WAG302v2 communicates with another bridge-mode wireless
station. See "Point-to-Point Bridge Configuration" on page
• Multi-Point Bridge. The WAG302v2 is the "master" for a group of bridge-mode wireless
stations. Then all traffic is sent to this "master," rather than to other access points. See
Point Bridge Configuration" on page
• Repeater with Wireless Client Association. Sends all traffic to the remote AP. See
with Wireless Client Association" on page
Note: The Wireless Bridging and Repeating feature uses the default Security Profile to
send and receive traffic.
These configurations can be set up from the Advanced Access Point Settings page, shown in
Figure 4-4.
Advanced Configuration
4-10.
4-12.
v1.0, May 2006
4-9.
"Multi-
"Repeater
4-7