NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Table C-12 AP Management
Task
Revert to factory default
settings
Reboot the system
Viewing and Configuring System Information
The commands in
Table C-12
heading. This section includes commands for the following features:
•
Activity Log
•
Available Wireless Station List
•
Statistics
•
Rogue AP Detection
Table C-13 AP Information
Task
View the SysLog activity log
View all SysLog server information
Enable SysLog
Disable SysLog
Set the IP address of the SysLog server
Set the port number configured in the
SysLog server
View a list of wireless stations
View interface statistics
Turn Rogue AP Detection On
Turn Rogue AP Detection Off
View a list of unknown APs
View a list of known APs
Command Line Reference
Command
factory-reset
reboot
correspond to the pages on the Web UI under the Information
Command
get log-entry
get log detail
set log relay-enabled 1
set log relay-enabled 0
set log relay-host <ip_address>
set log relay-port <port_number>
get association detail
get interface all ip mac ssid tx-
packets tx-bytes tx-errors rx-packets
rx-bytes rx-errors
set radio wlan0 ap-detection on
set radio wlan0 ap-detection off
get unknown-ap
get known-ap-config
v1.0, May 2006
C-15