Configuring Advanced Ip Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Table C-13 AP Information (continued)
Task
Add an AP to the Known AP list
Delete an AP from the Known AP list
Delete all APs from the Known AP list
Save (export) the list of Known APs.
Import a list of known APs

Configuring Advanced IP Settings

The commands in Table C-14
Advanced heading.
Table C-14 Advanced IP Settings
Task
View all DHCP server information
Enable the DHCP Server
Disable the DHCP Server
Set the Starting IP Address
Set the Ending IP Address
Set the Subnet Mask
Set the Gateway IP Address
C-16
Command
add known-ap-config <mac_address>
remove known-ap-config <mac_address>
remove known-ap-config all
set known-ap-list action export config-
file <file_name> config-server
<tftp_server/path>
Example:
set known-ap-list action export config-
file wag302Rogue3.cfg config-server
tftp://192.168.24.10/knownAP
set known-ap-list action import config-
file <file_name> config-server
<tftp_server>
Example:
set known-ap-list action export config-
file wag302Rogue3.cfg config-server
tftp://192.168.24.10/knownAP
correspond to the IP Settings page on the Web UI under the
Command
get dhcp-server detail
set dhcp-server status up
set dhcp-server status down
set dhcp-server ipstart <ip_address>
set dhcp-server ipend <ip_address>
set dhcp-server netmask <subnet_mask>
set dhcp-server gateway <ip_address>
v1.0, May 2006
Command Line Reference