Viewing And Configuring Management Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual

Viewing and Configuring Management Settings

The commands in Table C-12
heading. This section includes commands for the following features:
• Change Password
• Remote Management
• Upgrade Firmware
• Backup and Restore
• Reboot the System.
Table C-12 AP Management
Task
Set a password for admin
access to the AP.
Enable Remote CLI Access
Disable Remote CLI Access
Enable SNMP
Disable SNMP
Set a Public Community name
Set a Private Community
name
Set an IP address to receive
SNMP traps
Upgrade the firmware
(requires a reboot)
Backup the configuration file
Restore the configuration file
C-14
correspond to the pages on the Web UI under the Management
Command
set system password <password>
set ssh status up
set ssh status down
set snmp status up
set snmp status down
set snmp ro-community <string>
set snmp rw-community <string>
set traphost host <ip_address>
firmware-upgrade <url>
Example:
firmware-upgrade tftp://1.2.3.4/upgrade.tar
firmware-upgrade file://1.2.3.4/tmp/upgrade.tar
config download <url>
Example:
config download tftp://1.2.3.4/defaultcfg.xml
config upload <url>
Example:
config upload tftp://1.2.3.4/defaultcfg.xml
v1.0, May 2006
Command Line Reference