I Am Unable To Download Files From Some Ftp Sites; I Need To Restore Factory Default Settings; Default Factory Settings - NETGEAR WAG302 - ProSafe Dual Band Wireless Access Point Reference Manual

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual

I am unable to download files from some FTP sites.

If the IP address of the WAG302v2 LAN interface is not on the same network as the IP addresses
the DHCP server on the WAG302v2 assigns to wireless clients, the WAG302v2 performs
automatic network address and port translation (NAPT). Some higher-layer protocols, such as FTP,
might not work with the NAPT on the WAG302v2.
To fix this issue, reconfigure the DHCP server settings (Advanced IP Settings) so that the wireless
clients receive IP addresses that are on the same network as the WAG302v2 Ethernet interface.

I need to restore factory default settings.

To restore the factory default settings, you can use the Reset button (see "Using the Reset Button
to Restore Factory Default Settings" on page 3-6) or use the Backup/Restore Settings menu (see
"Erasing the Configuration" on page 3-6). To view a list of the factory default settings, see
"Default Factory Settings" on page B-1.
5-4 Troubleshooting
v1.0, May 2006