Connecting The Interface Cable; Connecting The Ac Power Cord - NEC 1260 - SuperScript - Printer User Manual

Connecting the Interface Cable

Use a good quality parallel cable to connect this
printer to a computer. Connect the interface cable
as described below.
1. Make sure the power switch is set to OFF [O].
2. Plug the interface cable connector into the
printer and then secure the lock springs.
3. Connect the other end of the cable to the
computer. Refer to the computer manual for
details about selection of a proper interface
connector.

Connecting the AC Power Cord

1. Make sure the power switch is set to OFF [O].
2. Plug the other end of the AC power cord into
Lock Springs
Connecting the Interface Cable
Plug the AC power cord into the AC socket
located on the printer rear cover.
a grounded AC wall outlet.
Caution! Be sure the voltage at the AC
wall outlet is correct for your printer.
Serious printer damage will result if your
printer is the 115VAC model and your AC
wall outlet is providing 220VAC.
1-15