Removing A Processor; Removing And Installing The Small Air Baffle; Figure 26. Installing The Heat Sink (1U Passive Heat Sink Shown) - Intel SR1560SFHS - Server System - 0 MB RAM Service Manual

3. Gradually and equally tighten each captive screw until each is firmly tightened.

Figure 26. Installing the Heat Sink (1U Passive Heat Sink Shown)

Removing a Processor

1. Loosen the four captive screws on the corners of the heat sink.
2. Twist the heat sink slightly to break the seal between the heat sink and the
processor.
3. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again. Do not force the heat sink from the processor. Doing so could damage the
processor.
4. Lift the processor lever.
5. Raise the CPU load plate.
6. Remove the processor.

Removing and Installing the Small Air Baffle

Some installation processes will require that you remove the small air baffle that is placed
behind the hard drive bays, near the front of your server. The steps below describe how to
remove and then install the small air baffle. Use these steps only when it is necessary for a
component installation process.
30
2
4
3
1
AF002386
®
Intel Server System SR1560SF Service Guide