Table of Contents
Advertisement
Configuring Fibre Channel Routing Services and Protocols
Step 3
Retransmitting Intervals
You can specify the time after which an unacknowledged link state update should be transmitted on the
interface. The integer value to specify retransmit intervals can range from 1 to 65,535 seconds.
Note
This value must be the same on the switches on both ends of the interface.
Configuring Retransmitting Intervals
You can configure the FSPF retransmit time interval.
Procedure
Step 1
Step 2
Step 3
OL-30895-01
Command or Action
fspf dead-interval value vsan vsan-id
Example:
switch(config-if)# fspf
dead-interval 60 vsan 101
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
switch(config)# interface fc slot/port
fspf retransmit-interval value vsan
vsan-id
Example:
switch(config-if)# fspf
retransmit-interval 10 vsan 25
Cisco Nexus 5500 Series NX-OS SAN Switching Configuration Guide, Release 7.x
FSPF Interface Configuration
Purpose
Specifies the maximum interval for the specified VSAN
before which a hello message must be received on the
selected interface before the neighbor is considered lost.
The default is 80 seconds.
Purpose
Enters global configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
If this is a QSFP+ GEM, the slot/port syntax
Note
is slot/QSFP-module/port.
Specifies the retransmit time interval for
unacknowledged link state updates in the specified
VSAN. The default is 5 seconds.
175
Advertisement
Table of Contents
