Configuring Custom Lacp Short Period Time Intervals - Cisco 6000 Series Configuration Manual

Configuring Custom LACP Short Period Time Intervals

Command or Action
Configuring Custom LACP Short Period Time Intervals
This section describes how to configure custom short period time intervals (less than 1000 milliseconds) for
sending and receiving LACP packets on a Gigabit Ethernet interface.
Note
You must always configure the transmit interval at both ends of the connection before you configure the
receive interval at either end of the connection. Failure to configure the >transmit interval at both ends first
results in route flapping (a route going up and down continuously). When you remove a custom LACP short
period, you must do it in reverse order. You must remove the receive intervals first and then the transmit
intervals.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12. exit
13. Repeat Step 7 through Step 12 to add more VLANs to the bundle you created in Step 2.
14. Do one of the following:
15. exit
16. exit
17.
18. configure
19. interface {GigabitEthernet | TenGigE} interface-path-id
20. bundle id bundle-id [mode {active | on | passive}]
21.
22. Repeat Step 19 through Step 21 to add more Ethernet interfaces to the VLAN bundle.
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
86
configure
interface Bundle-Ether bundle-id
ipv4 address ipv4-address mask
bundle minimum-active bandwidth kbps
bundle minimum-active links links
bundle maximum-active links links
exit
interface Bundle-Ether bundle-id.vlan-id
dot1q vlan vlan-id
ipv4 address ipv4-address mask
no shutdown
• end
•
• commit
show ethernet trunk bundle-ether instance
no shutdown
Purpose
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Configuring Link Bundling