Brake Stop Switch - DAELIM Daystar VL125E Service Manual

Maintenance
Height Adjustment
Adjust the brake pedal height to 10-20mm.
CAUTION
!
The adjustment faulty of height may caused
that the brake runs in state of operation.
Loosen the lock nut, and then adjust the height
by turning the brake pedal stoper bolt. After
adjusting, tighten the lock nut securely.
After adjusting the brake pedal height, inspect
the operation of rear brake light switch and
brake pedal, and adjust them if necessary.

Brake Stop Switch

Adjust the brake light switch so that the brake
light may come on, when the brake pedal is
depressed, and brake engagement begin. Hold
the switch body and turn the adjusting nut.
Headlight Adjustment
Adjust the headlight beam by turning the case
adjustment screw.
NOTE
Adjust the headlight beam as specified by
local laws and regulations.
CAUTION
!
An improperly adjusted headlight may blind
on coming drivers, or it may fail to light a road
for a safe distance.
Clutch
Measure the clutch system free play at the end
of clutch lever.
Free Play: 10~20mm(0.393~0787 in)
3-12
Stoper Bolt Stoper Bolt
Stoper Bolt Stoper Bolt
Stoper Bolt Stoper Bolt Stoper Bolt Stoper Bolt
Stoper Bolt Stoper Bolt Stoper Bolt Stoper Bolt
Stoper Bolt
Stop Switch Stop Switch Stop Switch Stop Switch
Stop Switch Stop Switch Stop Switch Stop Switch
Stop Switch Stop Switch
Stop Switch Stop Switch Stop Switch
Adjust Nut Adjust Nut Adjust Nut Adjust Nut
Adjust Nut Adjust Nut Adjust Nut Adjust Nut
Adjust Nut Adjust Nut
Adjust Nut Adjust Nut Adjust Nut
Bolt Bolt
Bolt Bolt
Bolt Bolt Bolt Bolt Bolt Bolt
Bolt Bolt Bolt