DAELIM Daystar VL125E Service Manual page 137

Cylinder Head / Valve
Hold the tensioner shaft with the light clip as
shown Install a new gasket into the tensioner
lifter, then install the tensioner lifter into the
cylinder.
Install the tensioner mounting bolt.
Torque:1.2kgf-m(12N.m)
From the tensioner lifter, remove the clip
which holds the tensioner shaft.
Install the O-RING and screw on the tensioner
lifter
Torque:0.4kgf-m(4N.m)
Apply clean engine oil to all the operation
parts of the cylinder head.
Adjust the valve clearance(
Install the crankshaft hole cap and timing hole
cap.
Torque:
Crank shaft hole cap: 0.8kgf-m(8N.m)
Timing hole cap: 0.6kgf-m(6N.m)
Clean oil in the slot part
head cover.
Place the gasket on the correct position in the
cover.
Install the cylinder head cover.
Tighten the cylinder cover bolt.
Torque:1.0kgf-m(10N.m)
Install the fuel tank(
9-16
3-6)
of the cylinder
4-3)
Tensioner Lifter
Screw Screw
Screw Screw
Screw Screw Screw Screw
Screw Screw Screw Screw
Screw
Mounting Bolt Mounting Bolt
Mounting Bolt Mounting Bolt
Mounting Bolt Mounting Bolt Mounting Bolt Mounting Bolt
Mounting Bolt Mounting Bolt Mounting Bolt Mounting Bolt
Mounting Bolt
Gasket Gasket
Gasket Gasket
Gasket Gasket Gasket Gasket
Gasket Gasket Gasket Gasket
Gasket