Brake Stop Switch; Headlight Aim; Clutch System; Brake Pedal Height Adjustment - DAELIM Roadwin R Service Manual

INSPECTIONS / ADJUSTMENTS
STOPPER BOLT STOPPER BOLT STOPPER BOLT
STOPPER BOLT STOPPER BOLT
STOPPER BOLT STOPPER BOLT STOPPER BOLT STOPPER BOLT STOPPER BOLT STOPPER BOLT
STOPPER BOLT STOPPER BOLT STOPPER BOLT STOPPER BOLT
STOPPER BOLT

BRAKE STOP SWITCH

BRAKE STOP SWITCH BRAKE STOP SWITCH
BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH
BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH
BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH BRAKE STOP SWITCH
2-12

BRAKE PEDAL HEIGHT ADJUSTMENT

Loosen the lock nut and turn the stopper bolt until
the correct pedal height is obtained.
After adjustment, tighten the lock nut securely.
The adjustment faulty of height may caused that the
brake runs in state of operation.
After adjusting the brake pedal height, inspect the
operation of rear brake light switch and brake pedal,
and adjust them if necessary.
BRAKE STOP SWITCH
Adjust the brake stop switch by turning the adjust
nut, pressing the switch so that the brake light will
come on just before the brake pedal is depressed
and brake engagement begins.

HEADLIGHT AIM

Adjust the headlight beam vertically by turning the
headlight case adjustment bolts.
Adjust the headlight beam as specified by local
laws and regulations.
An improperly adjusted headlight may blind
oncoming drivers, or it may fail to light the road
for a safe distance.

CLUTCH SYSTEM

Measure the clutch lever free play at the end of the
clutch lever.
FREE PLAY : 10~20mm